This procedure is specific to the eufy RoboVac L70 Hybrid. It uses a removable mopping module and a separate waterproof pad under the charging base. Do not transfer this setup or its liquid rules to another eufy model.
Prepare the hard floor and robot
- Use the L70’s current app instructions to set no-mop zones over any carpeted areas. The manufacturer’s linked setup visuals can change, so verify the current controls in the app.
- Install the waterproof pad beneath the charging base before mopping.
- Wet the mopping cloth, then wring it until it no longer drips. Attach it to the mopping module.
- Fill the L70 water tank with cold tap water only. Do not add hot water or cleaning solution. Insert the tank until it clicks into place.
- Use this mode on a clean hard floor, not over carpet or stubborn stains. eufy recommends vacuuming two or three times first. Select mopping mode in the EufyHome app; its Mop Mode Settings can adjust water release.
If the tank does not click into place, the cloth drips, or the model does not match, stop and check the exact L70 instructions before starting.
After mopping
Remove the mopping module and cloth after the run. Wash the cloth thoroughly and let it dry before storing or using it again; eufy recommends this to reduce mildew risk. Do not leave a damp cloth attached for long-term storage.
The linked no-mop-zone setup media are not preserved in the text instructions. Follow the current eufy app and product support page for the exact setting steps. This guide does not cover tank, pump, or electrical repair. For self-washing and water-system docks, use general dock care; the separate X10 Pro Omni T2351 guide covers a different eufy system.